TENT SETUP INSTRUCTIONS
MODEL 2000005799
Before you begin
Connect Leg Poles
(Fig. 3, Fig. 4 and 5)
Read all instructions before set up.
• Insert top poles and leg poles into pole connectors.
• Select a level site clear of rocks, branches, and other hard
or sharp objects, to install your tent.
2
• Insert one pin into each leg pole. (Fig.6)
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees because of potential
lightning strikes or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent
property damage or personal injury.
Pole Connector
• For best results in windy conditions, position narrow end
of tent into the wind.
• Enlist the help of at least one other person to assist you
when it is time to assemble the tent.
Pole
Pole Descriptions
Pole
No.
Description
Qty.
Pole
Pole
Repair Kit Replacement Kit
Fig. 5
Fig. 4
1
2
Main Roof Pole, grey
Side Roof Pole, black
w/Red mark
2
2
5010000539
5010000539
5010000549
5010000549
3
4
5
6
Side Roof Pole, black
w/Yellow mark
Front & Rear Roof Pole, black
w/Green mark
Center Steel Leg Pole
w/ red mark
Side Steel Leg Pole
2
2
4
4
5010000540
5010000540
N/A
5010000548
5010000548
5010000753
5010000761
N/A
Layout & Positioning
of Tent and Poles
5
6
Fig. 3
1
Pole
Pin
• Layout and position the tent with door facing desired direction. (Fig. 1)
• Stake down tent corners first through the stake rings. (Fig. 2)
• Keep the floor taut.
• Stake down the remainder of the stake rings.
• Assemble all poles by unfolding and interlocking the shock-corded
pole sections.
• Insert the body poles into the pole sleeves.
4
Clip
Fig. 6
Fig. 7
1
Attach Tent to Leg Poles
Using Clips
3
4
3
• Attach clips along the edges of tent to leg poles. (Fig. 7)
• Make any adjustments to the tent stakes, if needed.
Fig. 1
Pole
Sleeve
2
Attach Rainfly
• Drape rainfly over tent. (Fig. 9)
Tent Stake
• Connect the elastic loops with “S” hooks, (found at the rainfly
corners) to the frame poles. (Fig. 10)
• Secure rainfly with straps located on the underside of
rainfly. (Fig. 11)
• Attach and stake out guylines. (Fig. 9)
HINT: During setup, keep door zipped to keep proper tension on
fabric.
Stake Ring
(continued on other side)
Fig. 2
|