Dynasty Spas Hot Tub SSPA 1 User Manual

SSPA-1 SPA PACK

• Single-Pump System •

This Quick Reference Card is a summary of your spa's main functions and

provides a quick overview of operations accessible from your spa side keypad.

To start the pump:

"Pump" indicator light

Press the Pump key to turn the pump on at low speed.

A second press will turn the pump to high speed. A third

press will turn the pump off. A built-in timer will shut the

pump off after 20 minutes unless it has been manually

deactivated.

The "Pump" indicator light will be on when the

Pump is running.

To turn the light on:

"Light" indicator

Press the Light key to turn the light on. A second press

will turn the light off. A built-in timer will shut the light off

after 2 hours unless it has been manually deactivated.

The "Light" indicator will be on when the light

is on.

To change the water temperature:

"Heater" & "Set Point" indicator lights

Press the Up or Down arrow key to increase or decrease

the desired water temperature. The selected temperature

setting will be displayed for 5 seconds as a confirmation.

The "Set Point" indicator light indicates that the

temperature shown is the desired, and not the

current, temperature of the water!

The temperature can be adjusted in 1-degree increments

from 59 to 104˚F (15 to 40˚C).

Water heater automatic start:

When the water temperature is 1˚F (0.5˚C) lower

than the set point, the heater will be turned on automati-

cally until the water temperature reaches the set point

plus 1˚F (0.5˚C).

The "Heater" indicator light will be on when the

heater is on.

Note: If your system is configured in Low Current Mode,

the heater will not start if the pump is running at high speed.

Quick Reference Card