PMK 550 • Installation Guide
The Extron PMK 550 Pole Mount Kit, designed for use with the Extron PoleVault™ System, allows for easy mounting of PoleVault
products to a projector pole. The PMK 550 is compatible with both the PVS 204 series and PVS 305 series of PoleVault switchers.
When installed it mounts the PoleVault system switcher, the associated power supply, and an accessory device within an
enclosure below a suspended ceiling.
CAUTION: Maximum load for the PMK 550 is 15 lbs (6.8 kg).
Base Plate
Items included in the kit are:
Covers (2), Base plate (1), Mounting plate (1),
Tie wraps and pads (to secure power supply),
4-40 Screws (to mount devices) (3), Cover Screws, (4)
PMK Covers (2)
NOTE: For full device installation, configuration,
menus, connector wiring, and operation
details of the PoleVault switcher, see the
To open, remove 4 cover screws
and slide the covers away.
relevant PoleVault System Installation Guide
Mounting Plate (1)
Installation
To install the PMK 550 in a PoleVault system:
Figure 1. PMK 550
1. Remove the four cover screws from the center (see figure 1).
Slide the two halves apart and remove them from the base plate.
NOTE: If the PoleVault switcher and its power supply are
already installed, go directly to step 5.
2. To mount the PoleVault switcher, place the mounting plate, with the
raised tabs upwards, on top of the switcher top and pass the two
supplied 4-40 x 3/16 inch screws into the top of the switcher (see
figure 2, top). Secure the mounting plate but do not overtighten.
3. Hook the combined plate and switcher into the PMK 550 base plate.
Secure it to the base plate with two screws.
NOTES:
•
•
Any installed switcher should be secured to the plate
in an upside down position so that when the plate is
rotated to hang from the ceiling, the device will be in
its correct orientation (see figure 2, bottom).
5
A
U
X
A
U
D
IO
Use only supplied screws to avoid damaging the
switcher.
SENSO
IGNAL
R
SENSI
VITY
4. Attach the associated power supply with the supplied tie wraps and
pads, by passing them through the appropriate slots and around the
power supply (see figures 2 and 3). Tighten until snug.
CONFIG
A
U
X
A
UDIO
NORMAL
HE
SIGNA
L
R
V
O
ICELIF
T
NORMA
SIGNAL
P
A
GING
SENSOR
SENSI
TY
Figure 2. Installing the PVS Switcher
|